ELECTRICAL SYSTEM 16
235
Guideline
Insert holding lug
A
into cut-out
B
.
– Insert the screw and first turn counterclockwise until it
engages in the thread with a small jerk. Tighten the screw
lightly.
16.13 Checking the headlight setting
400726-10
– Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
B
under the first marking.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle perpendicular to the wall at a distance
A
from the wall and switch on the low beam.
Guideline
Distance
A
5 m (16 ft)
–
The rider now mounts the motorcycle with luggage and passen-
ger if applicable.
– Check the headlight setting.
To Next Page
Loading...
