KTM RC 250 R - Adding Front Brake Fluid; Checking Front Brake Linings

11 SERVICE WORK ON THE CHASSIS 44
L00538-10
Main work
–
Loosen nut
1
.
–
Adjust the chain tension by turning adjusting screws
2
on the left and right.
Guideline
Turn adjusting screws
2
on the left and right so that distance
A
is identical
on the left and right. The rear wheel is then correctly aligned.
–
Tighten nut
1
.
Guideline
Nut, rear wheel spindle M18x1.5 60 Nm
(44.3 lbf ft)
Finishing work
– Remove the rear of the motorcycle from the lifting gear. ( p. 35)
11.22 Checking the rear sprocket and engine sprocket
400227-01
– Check the rear sprocket and engine sprocket for wear.
» If the rear sprocket and engine sprocket are worn:
–
Replace the rear sprocket or engine sprocket. x