12 BRAKE SYSTEM 48
L00496-11
–
Remove cotter pin
3
, pull out pin
4
, and remove the brake linings.
– Clean the brake caliper.
L00496-12
–
Insert the brake linings
5
, insert pin
4
, and mount cotter pin
3
.
L00519-10
– Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
– Add brake fluid to the MAX level.
Brake fluid DOT 5.1 ( p. 94)
–
Mount and tighten screw cap
1
with membrane
2
and the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.
12.7 Checking rear brake fluid level
Warning
Danger of accidents Failure of the brake system.
– If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
– Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
L00539-10
– Stand the vehicle upright.
– Check the brake fluid level of the brake fluid reservoir.
»
If the fluid level reaches the MIN marking
1
:
–
Add rear brake fluid. x ( p. 49)
To Next Page
Loading...
