12 BRAKE SYSTEM 49
12.8 Adding rear brake fluid x
Warning
Danger of accidents Failure of the brake system.
– If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
– Avoid contact with skin and eyes, and keep out of the reach of children.
– Wear suitable protective clothing and goggles.
– If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
– Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid is corrosive and will damage painted surfaces.
Use only clean brake fluid from a sealed container.
Preparatory work
– Check the rear brake linings. ( p. 50)
– Raise the rear of the motorcycle with lifting gear. ( p. 35)
L00658-10
Main work
–
Loosen bleeder screw
1
.
L00656-10
–
Remove bleeder screw
2
.
L00657-10
–
Mount screw
3
and the syringe hose from the separate enclosure.
–
Correct the brake fluid level to level
A
using the syringe.
Guideline
Distance
A
2 mm (0.08 in)
Brake fluid DOT 5.1 ( p. 94)
To Next Page
Loading...
