KTM RC 250 R - Positioning the Quick Shifter

17 TUNING THE ENGINE 65
17.6 Positioning the quick shifter
Preparatory work
– Remove the engine cowl. ( p. 38)
L00652-10
Main work
–
Loosen nuts
1
.
–
Remove screws
2
.
L00653-10
–
Turn heim joints
3
into the desired position on both sides.
Info
The screw must be screwed in by at least 6 full turns.
The two heim joints must be parallel to each other.
– Check the ball joints of the heim joints for smooth operation.
L00652-10
–
Position the quick shifter and tighten with screws
2
.
Guideline
Screw, shift rod M6 12 Nm
(8.9 lbf ft)
Loctite
®
243™
–
Lock nuts
1
.
– Check the position of the quick shifter. ( p. 64)
Finishing work
– Install the engine cowl. ( p. 38)