16 ELECTRICAL SYSTEM
186
V00611-10
– Position the socket with the low beam bulb in the headlight
housing.
– Turn the socket clockwise.
– Check that the lighting is functioning properly.
Finishing work
– Check the low beam headlight setting. ( p. 188)
16.7 Changing the high beam bulb
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
– Clean and degrease the bulbs before mounting.
– Do not touch the bulbs with your bare hands.
Preparatory work
– Switch off the ignition by turning the ignition key to the posi-
tion .
To Next Page
Loading...
