Kubota EA330-E4 Series - Starter

ENGINE
EA330-E4, WSM
1-S42
(7) Starter
Magnet Switch
1. Disconnect the connecting lead.
2. Remove the mounting nut.
3. Remove the magnet switch (1) by sliding it up so that it is
disconnected from the drive lever.
9Y1211018ENS0064US0
Armature Brake
1. Remove the end frame cap (1).
2. Remove the brake shoe (2).
3. Remove the brake spring (3).
4. Remove the gasket (4).
(When reassembling)
• After reassembling the brake shoe (2), adjust the shaft thrust
gap.
9Y1211018ENS0065US0
End Frame
1. Remove the two through bolts.
2. Remove the end frame (1).
9Y1211018ENS0066US0
Brush Holder
1. Draw out the brush from the holder while holding the spring up.
2. Remove the brush holder (1).
(When reassembling)
• When replacing the spring, install it by referring to the figure.
• Do not contact the brush's positive lead with the body.
9Y1211018ENS0067US0
(1) Magnet Switch
(1) End Frame Cap
(2) Brake Shoe
(3) Brake Spring
(4) Gasket
(1) End Frame
(1) Brush Holder
(2) Spring Hanger
(3) Attach the brush spring in this
method
(4) Brush
KiSC issued 05, 2015 A