Kubota WG1605-E3 - Dtc List

ECM SYSTEM
WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, DM
1-102
[3] DTC LIST
DTC 16 87 88
Name Cam/Crank Sensors FP FP
DTC Name
Crank and/or Cam Could Not
Synchronize During Start
Fuel pressure low Fuel pressure high
J1939
SPN 636 94 94
FMI 810
MIL ON ON ON
Detected Item
• Mechanical misalignment between
cam and crank
• Fuel presure abnomality (Low side)
• Fuel presure abnomality (High side)
DTC Set
Preconditions
• Engine Cranking or Running • Engine Running • Engine Running
DTC Set
Conditions
• Cranking revs without sysnc > 4.0
revs
• and RPM > 90 min
-1
(rpm)
• FP fault mode Gasoline only
• run time wait for fuel pressure low
faults 5.0 sec
• FP pressure < 345 kPa [abs]
(3.52 kgf/cm
2,
50.0 psia)
• FP fault mode Gasoline only
• run time wait for fuel pressure high
faults 5.0 sec
• FP pressure > 448 kPa [abs]
(4.57 kgf/cm
2
, 65.0 psia)
Period for
Judgment or
Number of
Occurrence
for Judgment
•2 sec•2 sec•2 sec
System
Action
• None • AL Disable KC
• Low Rev Limit
• AL Disable KC
• Low Rev Limit
Engine
Warning Light
ON ON ON
DTC 91 92 107
Name FP FP MAP
DTC Name FP Low Voltage FP High Voltage MAP Low Voltage
J1939
SPN 94 94 106
FMI 434
MIL ON ON ON
Detected Item
• Sensor/wiring harness open/short
to ground
• Sensor malfunction
• Sensor/wiring harness short to
power
• Sensor malfunction
• Sensor/wiring harness open/short
to ground
• Sensor malfunction
DTC Set
Preconditions
• Key ON • Key ON • Engine Cranking or Running
DTC Set
Conditions
• FP voltage < 0.100 V • FP voltage > 4.90 V • MAP voltage < 0.050 V
• and TPS > 5.0 %
• and RPM < 4000 min
-1
(rpm)
Period for
Judgment or
Number of
Occurrence
for Judgment
•1 sec•5 sec•1 sec
System
Action
• AL Disable KC
• Low Rev Limit
• AL Disable KC
• Low Rev Limit
• AL Disable KC
• Power derate 1
Engine
Warning Light
ON ON ON
KiSC issued 12, 2016 A