ECM SYSTEM
WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, DM
1-29
[2] DIAGNOSTIC TOOL CONNECTION PROCEDURE
• At first time usage, it is necessary to install the software with administrator user account.
• Prepare a PC on which the diagnostic software has been installed.
• When connecting the diagnosis cable, don’t have to switch off the key of the vehicle.
1. Start up a PC on which diagnosis software has been
installed with administrator user account.
2. Connect the vehicle-side connector to the interface
(to vehicle) with administrator user account.
3. Connect the cable (USB) to the interface (to PC) and
then connect the USB connector to the USB port on
PC.
4. Start the diagnostic software.
• The power of diagnostic tool is supplied by the
USB port.
• After installed the software, all USB ports can be
used to connect the diagnosis cable.
• Connecting orders of diagnosis cables are not
important.
(1) Interface (To Vehicle) (2) Interface (To PC)
To Next Page
Loading...
