EasyManua.ls Logo

Kubota WG1605-G-E3 - Check Points of Every 200 Hours

Kubota WG1605-G-E3
145 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GENERAL
WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM
G-15
[5] CHECK POINTS OF EVERY 200 HOURS
Changing Engine Oil
CAUTION
Be sure to stop engine before changing engine oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw the drain plug (1).
5. Fill new oil up to upper line on the dipstick (2).
IMPORTANT
When using an oil of different maker or viscosity from the
previous one, remove all of the old oil.
Never mix two different types of oil.
Engine oil should have properties of API classification
better than SH.
Use the proper SAE Engine Oil according to ambient
temperature.
9Y1210661GEG0012US0
Replacing Oil Filter Cartridge
CAUTION
Be sure to stop the engine before changing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, fill the engine oil up to the specified level.
IMPORTANT
To prevent serious damage to the engine, replacement
element must be highly efficient. Use only a KUBOTA
genuine filter or its equivalent.
9Y1210661GEG0013US0
Checking LPG / Natural Gas Tank Setting Condition
(WG1605-L-E3,WG1605-N-E3, WG1605-GL-E3, WG1605-LN-E3,
WG1605-GLN-E3)
1. Check the setting condition of LPG / natural gas fuel tank.
9Y1210661GEG0016US0
Above 25 °C (77 °F) SAE30 or SAE10W-30 or SAE15W-40
0 °C to 25 °C (32 °F to 77 °F) SAE20 or SAE10W-30
0 °C to 20 °C (32 °F to 4 °F) SAE10W or SAE10W-30
Engine oil capacity
6.0 L
1.6 U.S.gals
Tightening torque Drain plug
32.4 to 37.3 N·m
3.31 to 3.80 kgf·m
23.9 to 27.5 lbf·ft
(1) Drain Plug (2) Dipstick
(1) Engine Oil Filter Cartridge
KiSC issued 05, 2014 A

Table of Contents

Other manuals for Kubota WG1605-G-E3

Related product manuals