Kubota WG1605-G-E3 - Oil Separator; Changing of Oil Separator Element; Rubber Piping Related Oil Separator; Replacement of Rubber Piping Related Oil Separator

35PERIODIC SERVICE
ENGLISH
[WG1903-G-E3 / WG1903-L-E3 / WG1903-GL-E3 /
WG1903-N-E3 / WG1903-LN-E3 /
WG2503-G-E3 / WG2503-L-E3 / WG2503-GL-E3 /
WG2503-N-E3 / WG2503-LN-E3]
[WG3800-G-E3 / WG3800-L-E3 / WG3800-GL-E3 /
WG3800-N-E3 / WG3800-LN-E3]
OIL SEPARATOR
BChanging of oil separator element
To avoid personal injury or death:
A Be sure to stop the engine before
changing the oil separator element.
1. Remove the cover and take out the oil separator
element and gasket. Then wipe oil and grease off the
zone in question.
2. Fit a new oil separator element and gasket into
position.
RUBBER PIPING RELATED OIL
SEPARATOR
BReplacement of rubber piping related oil
separator
Consult your local KUBOTA Dealer for this service.
(1) Fan belt
(2) Bolt and nut
(1) Fan belt
(2) Bolt and nut
(1) Oil separator
(1) Body
(2) Oil separator element
(3) Gasket
(4) Cover
EG523‑8917E.bookPage35Friday,October11,20199:54AM