17PERIODIC SERVICE
ENGLISH
BChanging engine oil
To avoid personal injury:
A Be sure to stop the engine before
draining engine oil.
A When draining engine oil, place
some container underneath the
engine and dispose it according to
local regulations.
A Do not drain oil after running the
engine. Allow engine to cool down
sufficiently.
1. Change oil after the initial 50 hours of operation and
every 200 hours thereafter.
2. Remove the drain plug at the bottom of the engine,
and drain all the old oil. Drain oil will drain easier when
the oil is warm.
3. Replace the drain plug gasket.
4. Add new engine oil up to the upper limit of the oil level
gauge.
BReplacing the oil filter cartridge
To avoid personal injury:
A Be sure to stop the engine before
changing the oil filter cartridge.
A Allow engine to cool down
sufficiently, oil can be hot and cause
burns.
1. Replace the oil filter cartridge after the initial 50 hours
of operation and every 200 hours thereafter.
2. Remove the old oil filter cartridge with a filter wrench.
3. Apply a film of oil to the gasket for the new cartridge.
4. Screw in the cartridge by hand. When the gasket
contacts the seal surface, tighten the cartridge enough
by hand. Because, if you tighten the cartridge with a
wrench, it will be tightened too much.
5. After the new cartridge has been replaced, the engine
oil level normally decreases a little. Thus, run the
engine for a while and check for oil leaks through the
seal before checking the engine oil level. Add oil if
necessary.
A Wipe off any oil sticking to the machine completely.
(1) Oil drain plug
(1) Oil filter cartridge
(2) Remove with a filter wrench
(Tighten with your hand)
EG523-8916-2_E.book 17 ページ ２０１１年１２月１９日 月曜日 午後４時５９分
To Next Page
Loading...
