Kubota WG3800-GL-E3 - Checking and Adding Engine Oil

PERIODIC SERVICE22
ENGLISH
BChecking oil level and adding engine oil
1. Check the engine oil level before starting or more than
5 minutes after stopping the engine.
2. Remove the oil level gauge, wipe it clean and reinstall
it.
3. Take the oil level gauge out again, and check the oil
level.
[WG1605-G-E3 / WG1605-L-E3 / WG1605-GL-E3 /
WG1605-N-E3 / WG1605-LN-E3]
[WG1903-G-E3 / WG1903-L-E3 / WG1903-GL-E3 /
WG1903-N-E3 / WG1903-LN-E3 /
WG2503-G-E3 / WG2503-L-E3 / WG2503-GL-E3 /
WG2503-N-E3 / WG2503-LN-E3]
[WG3800-G-E3 / WG3800-L-E3 / WG3800-GL-E3 /
WG3800-N-E3 / WG3800-LN-E3]
(1) Oil filler plug
(2) Oil level gauge
[Lower end of oil level gauge]
(A) Engine oil level within this
range is proper.
(1) Oil filler plug
(2) Oil level gauge
[Lower end of oil level gauge]
(A) Engine oil level within this
range is proper.
(1) Oil filler plug
(2) Oil level gauge
[Lower end of oil level gauge]
(A) Engine oil level within this
range is proper.
EG523‑8917E.bookPage22Friday,October11,20199:54AM