Venting the gas container
· From time to time you should “vent” your gas burner, i.e. completely
empty it of gas. In so doing, take care, in particular, that this is
carried out in a well-ventilated area and ensure that there are no
naked flames (e.g.
candles, or lit cigars or cigarettes) in the area.
· Carefully press the valve (8) down using an object (such as a small
screwdriver) and allow the remaining gas to escape.
Igniting
1. Move flame adjustment slide (2) to „+“position.
2. Push down the safety lock (3) until it clicks in place. pict B
3. Press ignition button (6). The flame will ignite instantly. pict C
For safety reasons, the ignition button will not depress
unless safety lock is locked in place!
Flame Adjustment
· Adjust the flame length during use by flame adjustment slide (2).
· Sliding towards the „+” symbol will make the flame longer, sliding
towards the „-“ symbol will make the flame shorter. For best results,
keep the flame length at about 1⁄2 -1 (10-25mm). Do not make the
flame too long as it will only waste fuel and make the flame unstable.
· To change the width and the temperature of the flame, slide the air
control lever (4) during the operation in the direction of flame
(= broader, cooler flame ) or toward ( = smaller, hotter flame )
· At the higher altitudes, torch may not operate on maximum flame
length setting (with slide pushed all the way to „+”). For best results,
adjust the slide to the mid-range between „+” and „-“.
GB
13
BA Crème Brûllée Brenner allgemein 2016_Layout 1 23.05.16 16:27 Seite 13
To Next Page
Loading...