THE KEYPAD
Filter Filling Warning (C Mark)
(After washing the filter, if you press the ON/OFF button for 5-6 seconds the system will reset and the display will return to its original status.)
Displays the operational range of the motor. Final stage is turbo mode--at this range, the display starts to flash before the product starts to
automatically operate at one range lower after 6 minutes. If you wish, you can then switch the product to the peak range.
Usage Without Chimney Connection (Carbon Filter)
Round Carbon Filters (Attached to the Motor)
Cartridge Type Carbon Filters
(Nano Carbon Filter)
The appliance you have purchased is compatible
with carbon filters.
1. Install the carbon filter in the motor’s housing.
2. Turn the carbon filter clockwise to make it sit
fully in the housing. Please refrain from washing
carbon filters that are fitted to both sides of the
motor. Normal usage requires these filters to be
changed every 3 months.
The cooker hood comes with aluminum filters.
You can simply disconnect them and replace
them with nano carbon filters of the same size.
You can wash (hand wash recommended) this
type of carbon filter. Normal usage requires
these filters to be changed every 24 months.
ON/OFF Motor Operation and Shutdown System Reset
Works for 15 Minutes Before Turning Off
.At whatever range your product works, it works for 10 minutes at that given
range and takes a 1-hour break. This process continues for 24 hours
Works for 15 Minutes Before Turning
Off
ON/OFF Motor Operation and Shutdown
To Next Page
Loading...