Kuka KR 20-3 - Stopping Distances and Times, KR 20-3; Stopping Distances and Stopping Times for STOP 0, Axis 1 to Axis 3

31 / 81Issued: 22.04.2016 Version: Spez KR 20-3 V2
4 Technical data
4.6.3 Stopping distances and times, KR 20-3
4.6.3.1 Stopping distances and stopping times for STOP 0, axis 1 to axis 3
The table shows the stopping distances and stopping times after a STOP 0
(category 0 stop) is triggered. The values refer to the following configuration:
 Extension l = 100%
 Program override POV = 100%
 Mass m = maximum load (rated load + supplementary load on arm)
Fig. 4-18: Extension
Stopping distance (°) Stopping time (s)
Axis 1 16.18 0.17
Axis 2 12.96 0.17
Axis 3 10.51 0.11