EasyManua.ls Logo

Kunft KBIO4445 - Page 7

Kunft KBIO4445
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 13
KBIO4445
EN
built in oven
Never use a damaged oven! Disconnect
it from the power source and contact your
supplier if it is damaged.
Danger of electric shock! Do not attempt
to repair the oven yourself. In case of mal-
function, repairs are to be conducted by
qualied personnel only.
To avoid damaging the cord, do not squee-
ze, bend or chafe it on sharp edges. Keep
it away from hot surfaces and open ames
as well.
Lay out the cord in such a way that no
unintentional pulling or tripping over it is
possible.
Do not open the oven casing under any
circumstances. Do not insert any foreign
objects into the inside of the casing.
Never use accessories not recommended by
the manufacturer; they could pose a safety
risk to the user and might damage the oven.
Only use original parts and accessories.
Keep the oven away from any hot surfaces
and open ames. Always operate the oven
on a level, stable, clean and dry surface.
Protect the oven against heat, dust, direct
sunlight, moisture, dripping and splashing
water.
Do not place objects with open ames, e.g.
candles, on top of or beside the oven.
WARNING: ensure the oven is switched
off before replacing the lamp to avoid the
possibility of electric shock.
The xed wiring for applicant shall have an
all-pole disconnection device.
Safety:
Attention: the glass is extremely fragile.
Always wear gloves when handling.
For your safety, this product is made of
tempered glass. This type of glass is hi-
ghly resistant but has a “memory” of sho-
cks retaining feature.
Therefore, handle the product with the gre-
atest care to avoid shocks and twists, es-
pecially during installation.
Avoid installing this type of product in are-
as where it would be highly exposed to
shocks.
Do not let children play with the oven.
Do not stick adhesive lm on the glass sur-
face. In case of breakage, it would gene-
rate large pieces that could be dangerous
Danger of electric shock!
Any electrical installation must be carried
out by an authorised professional only.
All ttings must be installed by a compe-
tent person in accordance with local regu-
lations. If in doubt, consult a qualied elec-
trician.
Important: always switch off the electrici-
ty supply at the mains during installation