PAGE 3
308955
DPF-MRK-003 REV A 1/15/18
PASSENGER ARMRESTS FOR TOURING & TRI GLIDE, CHROME 8955
866 277 9598 | INFO@KURYAKYN.COM
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYAKYN.COM
INSTALLATION INSTRUCTIONS
-CONTINUED-
INSTALL DRINK HOLDER IN LEFT-SIDE ARMREST PAD:
STEP 16
Remove the shoulder bolt and wave washer from the bottom side of the
drink holder.
STEP 17
Refer to PIC 9. Align the drink holder with the threaded hole in the
other pad; insert the shoulder bolt with wave washer through the drink
holder; tighten the shoulder bolt and TORQUE TO 15 IN LBS (1.69 NM).
PERIODIC REMOVAL, CLEANING, AND GREASING OF ARMREST STUD IS
RECOMMENDED.
PASSENGER ARMRESTS ARE NOT A SAFETY RESTRAINING DEVICE.
FAILURE TO HOLD ONTO THE MOTORCYCLE MAY RESULT IN SERIOUS
INJURY OR DEATH.
THIS PRODUCT WAS DESIGNED FOR USE AS A PASSENGER ARMREST
ONLY. DO NOT USE IT TO ASSIST MOUNTING OR DISMOUNTING THE
MOTORCYCLE. DO NOT APPLY YOUR FULL BODY WEIGHT TO THE
ARMRESTS TO ADJUST SEATING POSITION.
IT IS THE INSTALLER’S RESPONSIBILITY TO ENSURE THAT ALL OF THE
FASTENERS (INCLUDING PRE-ASSEMBLED) ARE TIGHTENED BEFORE
OPERATION OF THE MOTORCYCLE. KURYAKYN WILL NOT PROVIDE
WARRANTY COVERAGE ON PRODUCTS OR COMPONENTS LOST DUE
TO IMPROPER INSTALLATION OR LACK OF MAINTENANCE. PERIODIC
INSPECTION AND MAINTENANCE ARE REQUIRED ON ALL FASTENERS.
PIC 7
PIC 8
PIC 9
PRESS
ADJUSTMENT
BUTTON
INWARD
ADJUST TO
HIGH, MID,
OR LOW
SWING THE
DRINK HOLDER
OUT UNTIL IT
“CLICKS” INTO
ITS DETENT
REMOVE SCREW,
INSTALL IN OTHER
PAD; TORQUE TO
15 IN-LB (1.69 NM)
To Next Page
Loading...