Kurzweil Artis SE - Foot Switches and Controllers; Audio Level Controls; Volume Slider; Audio in

Features of the Artis SE
Audio Level Controls
3-4
Foot Switches and Controllers
e Artis SE has sophisticated Pedal controller options allowing up to 4 Switch Pedals or
up to 2 Half Damper Pedals as well as a Continous Controller Pedal to be connected. By
default the Switch Pedals control SW1a - Sustain, SW1b - Sostenuto, SW2a - Sostenuto and
SW2b - Soft. e CC Pedal controls expression by default.
Each Zone in a factory Multi may have dierent pedal assignments, and pedals are all
independently assignable within each Zone of a user Multi.
Audio Level Controls
Volume Slider
is controls the output level of the Headphone and Audio Out jacks on the rear panel.
Audio In
On the back panel of the Artis SE you will nd a ⅛” sized stereo audio jack labelled AUDIO
IN.
You can plug your MP3 player into the Artis SE and play along with the recorded music.
ere is no volume control for the Audio Input on the Artis SE itself, so you should control
the mix volume of the Audio Input from the MP3 player itself.
Master EQ
e Master EQ allows you to have realtime control over the frequency response of all audio
generated in either Program or Multi Modes. When the Master EQ On/O button is “On”,
the rotary knobs can change the high, middle & low frequencies of the audio.
If the LED on the Master EQ On/O button is lit, this indicates that the Master EQ section
is now “on”.