Kurzweil Artis SE - Changing ID Numbers; Naming a User Program; Locating a Saved User Program

Program Mode
Saving User Programs
6-12
You can save Programs with ID numbers from 257 to 512. When you initially press the Save
button, the Artis SE always selects the next available unused ID number and displays the
current Program name. After specifying the Program ID number and name, press the Save
button again to complete the saving process.
Changing ID Numbers
To change the ID number, turn the Alpha Wheel or use the + and – buttons to select the
new ID number. You can also use the Bank, Category and Program/Multi buttons to select
an ID number, which is useful for organizing User Programs by Category. To do this, rst
select a Bank and Category button, then select a Program/Multi button to select an ID
within that category.
Naming a User Program
To rename the new Program press a Param/Channel button until you see “Rename Prog
as:”.
Rename Prog as: 1/2
Mixed Choir
_
e display shows the current Program name. Use the Alpha Wheel to select characters for
the new Program name. Press the + or – button to move the cursor to the other characters.
Program names can total 16 characters in length.
Locating a saved User Program
Press the Save button to complete the saving process, or press the Exit button to exit without
saving. After successfully saving, the Program will be selected in Program Mode in the User
Bank. To nd the Program again later, make sure to press the User bank button under the
Category button.