Multi Mode
Transposition
7-4
Choosing Category Default Multis
You can choose a “Category Default Multi” from each Category that will be recalled each
time you press that Category’s button. To save a Category Default Multi, rst select a Multi
using any Multi select method (Alpha wheel, – & + buttons, Category buttons, Program/
Multi buttons). A Category button for the current Category will have a lit LED. Next, press
and hold the currently lit Category button until the display shows a message indicating that
the Category Default Multi has been saved.
You can save one Category Default Multi per Category button.
Choosing Favorites
You can save six Favorite Multis (or Programs) from any Category to the six Favorite
Buttons. Once saved, these Favorite Multis can be recalled from any Mode with a single
button press. To save the currently selected Multi to a Favorite Button, press and hold a
Favorite Button until the display shows the message “Multi saved to fav. button.”
Transposition
e Transpose buttons can be used to change the tuning of notes played on the Artis SE
keyboard in semitones (ST), also known as half steps. is is a convenient way to change the
key of a song without learning to play it in a dierent key. e Transpose buttons are located
to the left of the display. e Transpose buttons also transpose MIDI notes sent to the USB
and MIDI out ports.
Press the Transpose – or + buttons to transpose the Artis SE keyboard down or up by one
semitone. e top line of the display shows the current transposition value. Pressing both
Transpose – & + simultaneously will reset the transposition to 0. To transpose up and
down by octave intervals (12 ST), press the Octave button and use – Transpose + buttons.
e maximum transposition value possible is +/–36 semitones.
e LEDs of the Transpose buttons indicate whether the current Multi is transposed up
(Transpose + LED is lit) or transposed down (Transpose – LED is lit). When there is no
transposition, neither Transpose button is lit.
To Next Page
Loading...
