Kurzweil Artis SE - Saving a Layer; Saving User Multis; Changing ID Numbers

Multi Mode
Saving User Multis
7-8
Saving a Layer
After setting the Layer parameters, press the Save button to the left of the display to begin
the saving process. See Save User Multis on page 7-8 for details on saving.
Once you have saved your Layer, you can continue to add Split or Layer Zones to the Multi
until you reach the maximum of four active Zones. Also, once you have saved your Layer,
you can edit controller assignments and other Multi parameters in Multi Edit Mode (see
Multi Edit Mode on page 8-1 for details).
Saving User Multis
To save changes to the current User Multi, or to save a changed Factory Multi to a User
Category, press the Save button once.
You can save Multis with ID numbers from 257 to 512. When you initially press the Save
button, Artis SE always selects the next available unused ID number and displays the current
Multi name.
Before Saving, you can specify the ID number and rename the Multi. After specifying the
Multi ID number and name, press the Save button again to complete the saving process.
Changing ID Numbers
To change the ID number turn the Alpha Wheel or use the – & + buttons to select the new
ID number. You can also use the Bank, Category and Program/Multi buttons to select an
ID number, which is useful for organizing User Multis by Category. To do this, rst press a
Bank and Category button, then press a Program/Multi button to select an ID within that
category.
If you choose an ID that is already in use, you will see an asterisk in the display after the ID
number. Press Save to overwrite the existing Multi, or choose a dierent ID.
Save Multi Over: 1/2
258*Samba Layers