Kurzweil Artis SE - Channel; Destination (Dest); Zone Status (Status); Entry Volume (Entryvol)

Multi Edit Mode
The Zone-specic Parameters
8-6
Channel
e Channel parameter determines the MIDI transmit channel for the currently selected
Zone. You can set this parameter to any of the 16 MIDI channels (1-16). You can assign
dierent Zones to the same channel, but only one Program can be loaded in a channel at a
particular time.
Destination (Dest)
e Destination parameter determines whether MIDI data generated by the currently
selected Zone is sent to the Artis SE sound engine, through the MIDI OUT port, or both.
You can set this parameter to any of the three destinations for this parameter:
NOTE: In the table below, MIDI OUT applies to both the 5-pin MIDI OUT and the USB
ports.
Local
MIDI data is sent only to the Artis SE sound engine. MIDI OUT is
disabled.
MIDI
MIDI data is sent only through MIDI OUT. e sounds of the Artis
SE are disabled.
Local+MIDI
MIDI data is sent both to the Artis SE sound engine and through
the MIDI OUT.
Select the desired destination depending on your needs. If you want to play the Artis SE,
but not send any MIDI information to other MIDI instruments, then select Local. If you
want to use the Artis SE strictly as a MIDI controller for the other modules in your MIDI
chain, then select MIDI. If you want to make use of the Artis SE’s sounds as well as use it as
a MIDI controller, then select Local+MIDI.
Zone Status (Status)
e Zone Status parameter determines whether the currently selected Zone is active or
muted. You can set this parameter to either of two states: Active or Muted. Use the Alpha
Wheel to make your selection.
Entry Volume (EntryVol)
e Entry Volume parameter determines the Volume MIDI message that the currently
selected Zone sends when the Multi is loaded. You can set this parameter to any volume
setting from None, 0 to 127.