Kurzweil Artis SE - Entry Pan; Aux Send Level (Auxsendlvl); Zone Channel Effects (Znchanfx); Transpose (Xpose)

Multi Edit Mode
The Zone-specic Parameters
8-7
Entry Pan
e Entry Pan parameter determines the Pan MIDI message that the currently selected Zone
sends when the Multi is loaded. You can set this parameter to any pan setting from None, 0
(full left pan) to 127 (full right pan). To pan to center, select 64 for this parameter.
Aux Send Level (AuxSendLvl)
e Aux Send Level parameter determines the auxiliary eects send level for the Program of
the currently selected Zone. You can select any level from Prog, 0 to 127.
Pressing both - & + buttons simultaneously will set this parameter to 10. A value of Prog uses
the default Aux Send Level that the current Zone’s Program uses in Program mode. To enter
a value of Prog, use the Alpha Wheel or - & + buttons to scroll lower than 0.
For a description of the auxiliary eects of a Multi, see “About Auxiliary Effects” on page 8-15
and Common Parameters on page 8-15.
Zone Channel Effects (ZnChanFX)
Use the ZnChanFX parameter to enable or disable the Insert eects Chain of the Program
in each Zone. Some Zones set to Enable may be displayed as (Enable). is means that there
are not enough eects resources available for that Zone, and that Zone’s Insert eects are
not loaded. If you want to use the Insert eects Chain for a Zone displayed as (Enable), try
setting other Zones to Disable.
Transpose (Xpose)
e Transpose parameter determines the transposition for the currently selected Zone. You
can set this to any value from -128 semitones to 127 semitones.
Low Key (LoKey)
e Low Key parameter determines the lower boundary of the currently selected Zone. You
can set this parameter to any note from C-1 to G9.
If, for example, you set Low Key to C4, then only keys at or above C4 will trigger a note for
the currently selected Zone. Keys below C4 will not trigger a note.
High Key (HiKey)
e High Key parameter determines the higher boundary of the currently selected Zone. You
can set this parameter to any note from C-1 to G9.