Kurzweil Artis SE - Entry Program Change (Entryprgchg); Bank Mode; Bend Range down (Bendrngdwn); Bend Range up (Bendrngup)

Multi Edit Mode
The Zone-specic Parameters
8-10
Entry Program Change (EntryPrgChg)
e Entry Program Change parameter determines whether or not the currently selected
Zone will send a MIDI Program change message when the Multi is loaded. You can set this
parameter to either O or On. When set to On, the Zone will send a MIDI Program change
message with the Program specied for the MIDI Program parameter (described above).
Bank Mode
e Bank Mode parameter determines the controller number with which MIDI Bank change
messages are transmitted. For MIDI Bank change messages, various manufacturers have
chosen dierent MIDI controller numbers. Most have chosen 0, 32, or both. In the case of
the Kurzweil K2600, it has its own unique controller number that it responds to. You can set
this parameter to any of the ve controller IDs listed below:
None
MIDI Bank change messages are disabled.
Ctl0
MIDI Bank change messages are sent with controller number 0.
Ctl32
MIDI Bank change messages are sent with controller number 32.
Ctl0/32
MIDI Bank change messages are sent with both controller numbers 0
and 32.
K2600
MIDI Bank change messages are sent with controller number 32.
(K2600 Program numbers 0-99.)
Bend Range Down (BendRngDwn)
e Bend Range Down parameter determines the lower bend of the Pitch Wheel. You can set
this parameter to any value between 0 semitones and 127 semitones, or to Prog, which uses
the Bend Range of the currently selected Program for the Zone.
Bend Range Up (BendRngUp)
e Bend Range Up parameter determines the upper bend of the Pitch Wheel. You can set
this parameter to any value between 0 semitones and 127 semitones, or to Prog, which uses
the Bend Range of the currently selected Program for the Zone.