Kurzweil Artis SE - Load (Fill)

Storage Mode
10-4
Load (Fill)?
e Load (Fill)? dialog allows you to load a le containing previously saved User
Programs and User Multis from a device connected to the unit via USB. e loaded User
Programs and User Multis will ll any available location.
With the Load (Fill)? option selected, press the + button to begin the process of
loading from the selected device (USB or PC). If the device is not attached or not recognized,
the display will prompt you to connect the selected device or unplug and reconnect it.
Follow the instructions on the display. If PC was selected for the Device option, then the
Artis SE will appear as a removable disk/drive on your computer. Copy the le, containing
your previously saved User Programs and User Multis, from your computer into the Artis SE
removable disk/drive.
If USB was selected for the Device option, use the Param/Channel ▲ or ▼ buttons to select
the le to load from the list of les on the Artis SE display. For either device, pressing the
+ button will load the le, the display shows “File Loading…”, and when complete
“File loaded.”
Pressing Exit (or the – button) will cancel the load operation and recall the Load
(Fill)? dialog.
If no le is in the Artis SE temporary drive during the load or an error occurs during the
load operation, then the display will show the error message, Load Error and a message
specifying the reason for the error.