Kurzweil Artis SE - System Mode Buttons; Run Artis SE; Update Software; Update

System Mode (Boot Loader)
System Mode Buttons
11-2
CAUTION: THE SYSTEM RESET AND FILE UTILITIES
OPERATIONS BOTH ERASE ALL USER OBJECTS..
System Mode Buttons
e navigation buttons perform the following functions in System Mode:
Exit Use the Exit button to return to the previous menu.
Similar to a “cancel” button.
+ Use the + button to conrm a selection and move into
sub-menu, if any. It functions like an “OK” button.
Param/Channel ▲ Use the Param/Channel ▲ button to select the next
menu item, menu item parameter or read Diagnostic test
messages.
Param/Channel ▼ Use the Param/Channel ▼ button to select the previous
menu item, menu item parameter or read Diagnostic test
messages.
Run Artis SE
is is the rst System Mode menu item. Pressing the + button will load the OS and the
Artis SE will start up as if you just switched on the unit (except for the
message that happens when you rst start up the unit).
Update Software
Update Software has two parameters: Update and Restore. Select Update to install a new OS
and Objects version, or select Restore to the install the previous OS version. e new OS and
Object les are combined in one le (.KUF).
Update
1. Obtain the Update le from the Kurzweil website or another reliable source and save it
in a known folder or directory on your computer.
2. Connect the Artis SE (powered o) to your computer with a USB cable.