Kurzweil Forte SE - The MOD Pages

The Effects Chain Editor
The MOD Pages
8-2
Like all other representations of signal paths in the Forte SE display, the program signal
moves from left to right through the Chain. Use the cursor buttons to select an eect-box
or empty spot in the Chain. e eect loaded into the selected eect-box can be changed
by numeric entry, with the Alpha Wheel, or with the +/– buttons; and can be changed with
either the eect-box or the Eect eld at the bottom of the page highlighted. e +/- double
button press will jump to the next eect “category.”
Pressing the Insert soft button adds a new eect-box to the Chain in the currently selected
block-slot, and pushes the currently selected eect-box down the Chain to the right. (If you
have run out of DSP units, you will not be able to create additional eects boxes.) Pressing
the Remove soft button takes the currently selected eect out of the Chain.
Editing Effect-boxes
To edit the parameters of an eect, select its eect-box on the MAIN page and press the Edit
button. For each eect, there are one or more pages of parameters that are specic to that
eect. See Effects Parameters on page 8-5 for details on parameters for each type of eect.
Any parameter controlled by an eect Mod will display a value of FxMod and cannot be
edited. To return to the MAIN page of the chain editor, press the Exit button.
The MOD Pages
ere are six pages for conguring eects mods: MOD1 - MOD6. All pages are essentially
identical in appearance and function. See below for an example MOD page:
Box
e Box parameter species which eect-box in the Chain to which the Mod will be applied.
Param
e Param parameter selects which parameter of the specied box’s eect will be modulated.
Adjust
e Adjust parameter sets a xed value for the specied parameter (Param) that is applied
before any modulation.