Kurzweil Forte SE - COMMON Page

Multi Edit Mode
COMMON Page
11-27
COMMON Page
e COMMON page contains parameters that aect every zone in the current Multi. Press
the COMMON soft button to enter the COMMON page.
Parameter Range Of Values Default Value
Tempo 20 to 400 BPM 120
Clock Source Internal, External Internal
Aux FX Chan 1 to 16 1
KB3 Channel 1 to 16 1
Tempo
When Clock Source (see page 12-4) is set to Internal, the Tempo parameter sets the Forte
SE’s system tempo for this Multi. e Tempo parameter values are in units of BPM (beats
per minute). is controls the tempo the Arpeggiators as well as of any tempo based eects.
Clock Source
With the Clock Source parameter, you can set the Forte SE—within the current Multi—to
generate its own tempo by setting Clock Source to Internal, or you can set the Forte SE to
sync up with the tempo from another device—assuming the device is sending MIDI clock
data to the Forte SE via MIDI or USB—by setting Clock Source to External. When Clock
Source is set to External, the Tempo parameter disappears from the display.
Aux FX Chan
e Aux FX Channel determines the FX channel through which all of the zones in the
current Multi are sent.
For example, if a zone 2 in a Multi has a program with 25 Basic Delay 1/8 as an Aux FX, and
zone 2 is assigned to channel 5, then setting the Aux FX Channel to 5 sends the programs of
all of the zones in the Multi through zone 2’s Program’s Aux FX (i.e., through 25 Basic Delay
1/8).
KB3 Channel
If KB3 Programs are selected for more than one Zone, this parameter species which MIDI
Channel has priority to load a KB3 Program. Only one KB3 Program can be loaded at a
time. If you want a KB3 Program to play in a zone, you should set the KB3 channel to the
channel of the Zone.