Program Mode and the Program Editor
Program Editor—LAYER Page
6-11
Program Editor—LAYER Page
Press the LAYER soft button to call up the LAYER page. Here you’ll set a number of parameters
that affect the current layer’s keyboard range, attack and release characteristics, and response
to various controls.
EditProg:LAYER|||||||||||||<>Layer:1/1||
LoKey|:C|0||DlyCtl:OFF|||||||SusPdl:On||
HiKey|:C|8||MinDly:0.000s||||SosPdl:On||
LoVel|:ppp||MaxDly:0.000s||||FrzPdl:On||
HiVel|:fff||Enable:ON||||||||IgnRel:Off|
PBMode:All||S:Norm|64||127|||ThrAtt:Off|
Trig||:Norm|Opaque:Off|||||||TilDec:Off|
<more||ALG||||LAYER||KEYMAP|PITCH||more>
PARAMETER RANGE OF VALUES DEFAULT
LOW KEY C -1 to G 9 C 0
HIGH KEY C -1 to G 9 C 8
LOW VELOCITY ppp to fff ppp
HIGH VELOCITY ppp to fff fff
PITCH BEND MODE Off, Key, All All
TRIG Normal, Reversed Normal
DELAY CONTROL Control Source list OFF
MINIMUM DELAY 0 to 25 seconds 0
MAXIMUM DELAY 0 to 25 seconds 0
LAYER ENABLE Control Source list ON
ENABLE SENSE Normal, Reversed / Min. / Max. Normal / 64 / 127
OPAQUE LAYER Off, On Off
SUSTAIN PEDAL Off, On, On2 On
SOSTENUTO PEDAL Off, On On
FREEZE PEDAL Off, On On
IGNORE RELEASE Off, On Off
HOLD THROUGH ATTACK Off, On Off
HOLD UNTIL SUSTAIN Off, On Off
Low Key (LoKey)
This sets the lowest active note for the current layer. This parameter’s value cannot be set
higher than the value for HiKey. The standard MIDI key range is C -1—G 9 (0-127). Middle C is
C 4 (ISP).
High Key (HiKey)
Here you set the highest active note for the current layer. This parameter’s value cannot be set
lower than the value for LoKey.
Low Velocity (LoVel)
With this parameter you define the lowest attack velocity at which the layer will be enabled
(generate a sound). The values for this parameter and the next are expressed in the standard
musical dynamics markings, similar to the values available for the velocity maps. Attack
velocities that are below this velocity threshold will not trigger notes. If you set this
parameter’s value higher than the HiVel value, the layer will not play at all.
High Velocity (HiVel)
Similarly, this will set the highest attack velocity at which the layer will be enabled. Attack
velocities above this velocity will not trigger notes in this layer.
To Next Page
Loading...
