Program Mode and the Program Editor
Program Editor— PITCH Page
6-17
Program Editor— PITCH Page
Press the PITCH soft button, and the PITCH page will appear. These parameters adjust the
pitch (playback rate) of the samples after the root has been selected by the keymap.
EditProg:PITCH|||||||||||||<>Layer:1/1||
Coarse:0ST|||||||||Src1||:OFF|||||||||||
Fine||:0ct|||||||||Depth|:0ct|||||||||||
FineHz:|0.00Hz|||||Src2||:OFF|||||||||||
KeyTrk:0ct/key|||||DptCtl:MWheel||||||||
VelTrk:0ct|||||||||MinDpt:0ct|||||||||||
|||||||||||||||||||MaxDpt:0ct|||||||||||
<more||ALG||||LAYER||KEYMAP|PITCH||more>
PARAMETER RANGE OF VALUES DEFAULT
COARSE ADJUST –120 to 60 ST (semitones) 0
FINE ADJUST (cts) ± 100 cents 0
FINE ADJUST (Hz) ± 6 Hz 0
KEY TRACKING ± 2400 cents per key 0
VELOCITY TRACKING ± 7200 cents per key 0
SOURCE 1 Control Source list OFF
DEPTH ± 7200 cents 0
SOURCE 2 Control Source list OFF
DEPTH CONTROL Control Source list MWheel
MINIMUM DEPTH ± 7200 cents 0
MAXIMUM DEPTH ± 7200 cents 0
These parameters were described in the section on common DSP control parameters earlier in
this chapter, so we won’t repeat them here, but a word about the Fine Hz parameter is in order.
Fine Hz
This measures pitch adjustment by the relative frequency (in Hertz) of each note. This is useful
for controlling the beat frequency between layers in a multi-layered program. Using this
parameter to detune chorusing layers will keep the beat frequency constant across much of the
keyboard. Although the ratio of frequencies between each layer remains constant, the detuning
will increase at lower pitches, and can become extreme. The K2500 automatically limits the
amount of detuning when it becomes extreme, so you’ll notice the beat frequencies moving out
of sync when you play low pitches.
To Next Page
Loading...
