Kurzweil K2500 - PERFORMANCE GUIDE REV F PART NUMBER 910252 CHAP 6

Control Sources
Constant Control Sources
6-14
Constant Control Sources
The remaining control sources are constants, which appear only when you’re assigning control sources as
inputs for the FUNs. Assigning one of these values fixes the input’s control signal value at a steady level.
133 -0.99
134 -0.98
135 -0.97
136-140 -0.96 to -0.92
141 -0.91
142 -0.90
143-145 -0.88 to -0.84
146-150 -0.82 to -0.74
151-155 -0.72 to -0.64
156-160 -0.62 to -0.54
161-165 -0.52 to -0.44
166-170 -0.42 to -0.34
171-175 -0.32 to -0.24
176-180 -0.22 to -0.14
181 -0.12
182 -0.10
183 -0.09
184 -0.08
185 -0.07
186-190 -0.06 to -0.02
191 -0.01
192 0.00
193 0.01
194 0.02
195 0.03
196-200 0.04 to 0.08
201 0.09
202 0.10
203 0.12
204 0.14
205 0.16
206-210 0.18 to 0.26
211-215 0.28 to 0.36
216-220 0.38 to 0.46
221-225 0.48 to 0.56
226-230 0.58 to 0.66
231-235 0.68 to 0.76
236-240 0.78 to 0.86
241 0.88
242 0.90
243 0.91
244 0.92
245 0.93
246-250 0.94 to 0.98
251 0.99
Note: There are no control sources that correspond to numeric entries 252—254.
256 OFF