Installing Version 2.5
2
910304, Rev. B
Installing Version 2.5
Note:
Back up your RAM objects before performing this installation. All RAM will be erased by the Hard
Reset at the end of the installation.
The complete procedure for installing the operating system and objects is included in Chapter 2 of the
K2500
Performance Guide
. For your convenience, here's a summary of the procedure:
1. Start the K2500
2. Press and release the Exit key while the "Please wait..." message is displayed. This brings up the K2500
Boot Loader.
3. Load the operating system floppy, then use "Install System" from the K2500 Boot Loader to install the new
operating system.
4. Replace the operating system disk (after you've installed it) with the factory objects disk, then use the Boot
Loader's "Install Objects" option to install the correct objects for your configuration.
Object file versions and K2500 ROM configurations for V2.5 are as follows:
OBJ300.K25 for Base ROM
OBJP310.K25 for Base + Piano option
OBJO320.K25 for Base + Piano + Orchestral option
OBJC330.K25 for Base + Piano + Contemporary option
OBJF340.K25 for Base + Piano + Orchestral + Contemporary option
The Object files that accompany Version 2.5 software add ten KB3 organ programs, three effects, and one
Quick Access Bank to the 700’s bank of your K2500.
5. When the installation is finished, choose "Hard Reset" followed by "Run System" from the Boot Loader.
While you won't normally need to reinstall the operating system or objects, you should still put the disks in a
safe place, just in case you may need them again.
To Next Page
Loading...
