KDFX Reference
KDFX Algorithm Speciļ¬cations
10-101
large sample skips (audible as clicks when signal is passing through the effect). There are
four of these parameters to include 2 pairs (A and B) for high and low frequency drivers.
Mic Lvl The level of the virtual microphone signal being sent to the output. There are four of these
parameters to include 2 pairs (A and B) for high and low frequency drivers.
Mic Pan Left-right panning of the virtual microphone signals. A settings of -100% is panned fully
left, and 100% is panned fully right. There are four of these parameters to include 2 pairs
(A and B) for high and low frequency drivers.
LoResonate A simulation of cabinet resonant modes express as a percentage. For realism, you should
use very low settings. This is for the low frequency signal path.
Lo Res Dly The number of samples of delay in the resonator circuit in addition to the rotation
excursion delay. This is for the low frequency signal path.
LoResXcurs The number of samples of delay to sweep through the resonator at the rotation rate of the
rotating speaker. This is for the low frequency signal path.
HiResonate A simulation of cabinet resonant modes express as a percentage. For realism, you should
use very low settings. This is for the high frequency signal path.
Hi Res Dly The number of samples of delay in the resonator circuit in addition to the rotation
excursion delay. This is for the high frequency signal path.
HiResXcurs The number of samples of delay to sweep through the resonator at the rotation rate of the
rotating speaker. This is for the high frequency signal path.
ResH/LPhs This parameter sets the relative phases of the high and low resonators. The angle value in
degrees is somewhat arbitrary and you can expect the effect of this parameter to be rather
subtle.
To Next Page
Loading...