KDFX Reference
KDFX Algorithm Specifications
10-109
Dist Drive Applies a boost to the input signal to overdrive the distortion algorithm. When
overdriven, the distortion algorithm will soft-clip the signal. Since distortion drive will
make your signal very loud, you may have to reduce the Out Gain as the drive is
increased.
Warmth A lowpass Þlter in the distortion control path. This Þlter may be used to reduce some of
the harshness of some distortion settings without reducing the bandwidth of the signal.
Lo Gain The gain or amplitude of the signal passing through the rotating woofer (low frequency
driver. The control is also available in KB3 AuxFX.
Lo Xover The crossover frequency for the low frequency driver. Lo Xover controls a lowpass Þlter.
Lo HP A highpass Þlter to simulate the band-limiting of a speaker cabinet. The Þlter controls the
lower frequency limit of the output.
Hi Gain The gain or amplitude of the signal passing through the rotating tweeter (high frequency
driver. The control is also available in KB3 AuxFX.
Hi Xover The crossover frequency for the high frequency driver. Hi Xover controls a highpass Þlter.
Hi LP A lowpass Þlter to simulate the band-limiting of a speaker cabinet. The Þlter controls the
upper frequency limit of the output.
Parameters for KB3 AuxFX
Page 1
Page 2
Page 3
In/Out In or Out Out Gain Off, -79.0 to 24.0 dB
Lo Gain Off, -79.0 to 24.0 dB Hi Gain Off, -79.0 to 24.0 dB
Lo Rate -10.00 to 10.00 Hz Hi Rate -10.00 to 10.00 Hz
Lo Size 0 to 250 mm Hi Size 0 to 250 mm
Lo Trem 0 to 100% Hi Trem 0 to 100%
Lo Beam W 45.0 to 360.0 deg Hi Beam W 45.0 to 360.0 deg
LoMicA Pos -180.0 to 180.0 deg LoMicB Pos -180.0 to 180.0 deg
LoMicA Lvl 0 to 100% LoMicB Lvl 0 to 100%
LoMicA Pan -100 to 100% LoMicB Pan -100 to 100%
HiMicA Pos -180.0 to 180.0 deg HiMicB Pos -180.0 to 180.0 deg
HiMicA Lvl 0 to 100% HiMicB Lvl 0 to 100%
HiMicA Pan -100 to 100% HiMicB Pan -100 to 100%
To Next Page
Loading...