Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910331 CHAP 10 - Page 34

10-34
KDFX Reference
KDFX Algorithm Specifications
Parameters
Page 1
Page 2
Page 3
Tempo Basis for the delay lengths, as referenced to a musical tempo in bpm (beats per minute).
When this parameter is set to ÒSystemÓ, the tempo is locked to the internal sequencer
tempo or to incoming MIDI clocks. When it is set to ÒSystemÓ, sources (FUNs, LFOs, ASRs
etc.) will have no effect on the Tempo parameter.
LoopLength The delay length of the Loop tap. If the feedback is turned up, this parameter sets the
repeating delay loop length. LoopLength sets the loop delay length as a tempo beat
duration. The tempo is speciÞed with the Tempo parameter and the delay length is given
in beats (bts). The delay length in seconds is calculated as beats/tempo * 60 (sec/min).
Tap n Delay The delay lengths of the taps (n = 1...4) as tempo beat durations. The tempo is speciÞed
with the Tempo parameter and the delay length is given in beats (bts). The delay length in
seconds is calculated as beats/tempo * 60 (sec/min). Use the output taps to create
interesting rhythmic patterns within the repeating loop.
Wet/Dry 0 to 100%wet Out Gain Off, -79.0 to 24.0 dB
Fdbk Level 0 to 100% Tempo System, 1 to 255 BPM
Dry Bal -100 to 100%
HF Damping 16 Hz to 25088 Hz Hold On or Off
LoopLength 0 to 32 bts
Tap1 Delay 0 to 32 bts
Tap2 Delay 0 to 32 bts
Tap3 Delay 0 to 32 bts
Tap4 Delay 0 to 32 bts
Tap1 Level 0 to 100 % Tap1 Bal -100 to 100 %
Tap2 Level 0 to 100 % Tap2 Bal -100 to 100 %
Tap3 Level 0 to 100 % Tap3 Bal -100 to 100 %
Tap4 Level 0 to 100 % Tap4 Bal -100 to 100 %