10-62
KDFX Reference
KDFX Algorithm Specifications
Notch/BP The amount of notch depth or bandpass. At -100% there is a complete notch at the center
frequency. At 100% the Þlter response is a peak at the center frequency. 0% is the dry
unaffected signal.
Out Gain The output gain in decibels (dB) to be applied to the Þnal output.
Feedback The phaser output can be added back to its input to increase the phaser resonance (left
and right). Negative values polarity invert the feedback signal.
Ctr Freq The nominal center frequency of the phaser Þlter (left and right). For a true phaser effect
you may want to modulate these parameters by setting up FX Mods.
Parameters for LFO Phaser Twin
Page 1
Notch/Dry The amount of phaser (wet) signal relative to unaffected (dry) signal as a percent. At 100%
the phaser produces a pair of full notches above and below the center frequency. At 200%
the output is a pure allpass response (no amplitude changes, but phase changes centered
about the center frequency).
CenterFreq The nominal center frequency of the phaser Þlter. When conÞgured for a maximum notch
(Notch/Dry is 100%), the CenterFreq speciÞes the frequency of the peak between two
notches. The LFO modulates the phaser Þlter centered at this frequency.
LFO Rate The rate of the phaser frequency modulating LFO in Hertz.
LFO Depth The depth in cents that the frequency LFO sweeps the phaser Þlter above and below the
center frequency.
L/R Phase The phase difference between the left and right channels of the LFO. A setting of 180
degrees results in one being at the minimum frequency while the other channel is at the
maximum.
Parameters for Vibrato Phaser
Page 1
Page 2
Notch/Dry 0 to 200%
CenterFreq 16 to 25088 Hz LFO Rate 0.00 to 10.00 Hz
LFO Depth 0 to 5400 ct L/R Phase 0.0 to 360.0 deg
Wet/Dry -100 to 100%wet Out Gain Off, -79.0 to 24.0 dB
CenterFreq 16 to 25088 Hz Bandwidth 0.010 to 5.000 oct
LFO Depth 0 to 100% L/R Phase 0.0 to 360.0 deg
LFO Rate 0.00 to 10.00 Hz
Rate Scale 1 to 25088x In Width -100 to 100%
To Next Page
Loading...