KDFX Reference
KDFX Algorithm Specifications
10-87
Page 2
Page 3
Parameters for MonoPitcher + Flan
Page 1
Page 2
Page 3
Wet/Dry This is a simple mix of the pitched and chorused or ßanged signal relative
to the dry input signal.
Out Gain The overall gain or amplitude at the output of the effect.
Mix Pitchr The amount of the pitcher signal to be sent directly to the output as a
percent. Any signal that this parameter sends to the output does not get
sent to the chorus or ßanger.
Pt Inp Bal -100 to 100% Pt Out Pan -100 to 100%
Pt Pitch C-1 to G 9 Pt Offset -12.0 to 12.0 ST
Pt PkSplit 0 to 100% Pt PkShape -1.0 to 1.0
ChPtchEnvL Triangle or Trapzoid ChPtchEnvL Triangle or Trapzoid
Ch Rate L 0.01 to 10.00 Hz Ch Rate R 0.01 to 10.00 Hz
Ch Depth L 0.0 to 100.0 ct Ch Depth R 0.0 to 100.0 ct
Ch Delay L 0.0 to 720.0 ms Ch Delay R 0.0 to 720.0 ms
Ch Fdbk L -100 to 100% Ch Fdbk R -100 to 100%
Ch Xcouple 0 to 100% Ch HF Damp 16 to 25088 Hz
Wet/Dry 100 to 100%wet Out Gain Off, -79.0 to 24.0 dB
Mix Pitchr -100 to 100%
Mix Flange -100 to 100% Fl Tempo System, 1 to 255 BPM
Pt/Dry->Fl 0 to 100%
Pt Inp Bal -100 to 100% Pt Out Pan -100 to 100%
Pt Pitch C-1 to G 9 Pt Offset -12.0 to 12.0 ST
Pt PkSplit 0 to 100% Pt PkShape -1.0 to 1.0
Fl LFO cfg Dual1Tap Fl LRPhase 0.0 to 360.0 deg
Fl Rate 1 0 to 32 bts Fl Rate 2 0 to 32 bts
Fl Xcurs 1 0.0 to 230.0 bts Fl Xcurs 2 0.0 to 230.0 bts
Fl Delay 1 0.0 to 230.0 ms Fl Delay 2 0.0 to 230.0 ms
Fl Phase 1 0.0 to 360.0 deg Fl Phase 2 0.0 to 360.0 deg
Fl Fdbk -100 to 100% Fl HF Damp 16 to 25088 Hz
To Next Page
Loading...