Kurzweil K2700 - The Mode Button Functions

Program Edit Mode
The Mode Button Functions
3-77
a new Parameter. At the prompt, choose a Destination and then name the Parameter. e
Parameter Destination is the default MIDI CC number that the Parameter will send to the
Program. e Destination also becomes the default Control for the Parameter. Once the
parameter is created, you can change its Control on the Parameters Page.
IGN EDIT
Press the IGN EDIT soft button to ignore edits to parameter values from physical
controllers. When the IGN EDIT soft button is pressed and colored red, moving physical
controllers which are assigned to parameters on the Parameters page will not change the
Value set on the Parameters page. is allows you to edit a program and try dierent
controller settings without losing the values that you had previously set on the Parameters
page.
DELETE
Press the DELETE soft button to delete the current Program (factory Programs can not be
deleted). Press DELETE, and you will be given a choice to DELETE or CANCEL. Press
DELETE again, and an “Are You Sure?” message will appear. Press YES to delete the Program,
or CANCEL to cancel.
The Mode Button Functions
In Program Edit Mode, the Mode buttons perform a secondary function when pressed.
PROGRAM (Solo Layer)
Press the PROGRAM Mode button to temporarily solo the currently selected Layer.
MULTI (Mute Layer)
For VAST layers, press the MULTI Mode button to temporarily mute the currently selected
Layer. For FM layers, press the MULTI Mode button to view the FM Operator Mute page.
SONG (FX Bypass)
Press the SONG Mode button to temporarily bypass the Insert and Aux FX Chains. See the
FX Bypass section above for more details.
GLOBAL (Compare)
Press the GLOBAL Mode button to temporarily recall an unedited version of the program,
allowing you to compare your edited program with the original program.