Kurzweil K2700 - FM Alt Input Page

Program Edit Mode
FM Alt Input Page
3-104
MaxDpt
Use the MaxDpt parameter to set the maximum modulation depth of Src2.
When a DptCtl control source is at its maximum value, Src2 will apply the amount of
modulation set by the MaxDpt parameter.
Output/Misc Parameters
e right-hand column of the FM Amp + Output page shows Output/Misc parameters for
the layer. e Output/Misc parameters for FM layers behave the same as the parameters on
the VAST layer Output page. For details on these parameters see ”The OUTPUT Page” on
page 3-62.
FM Alt Input Page
In classic FM synthesis, Operators containing sine wave oscillators are used to frequency
modulate other Operators in various congurations in order to create complex timbres. FM
layers allow you to use an alternate input for these Operators, allowing sources other than
FM Operators to be used for modulation of other FM Operators. is is useful for easily
creating complex timbres without complex congurations of Operators and modulation
sources.
e FM alternate input allows FM Operators in the current layer to be modulated by a
Keymap in the current layer, or by any type of audio signal from a dierent FM or VAST
layer. FM synthesis techniques can be combined with VAST synthesis features to create never
before heard sounds.