Kurzweil K2700 - Page 266

Multi Edit Mode
FX Page
7-43
Mod Override
e Mod Override parameter allows you to select a controller or modulation source which
will control the send level or dry/wet amount for the Aux 1 or Aux 2 Chain. Selecting a Mod
Override will disable any Aux Mod controller or modulation source that was assigned in the
Program of the Aux FX Channel.
If you select a MIDI controller for the Mod Override (entries 1 through 95 in the Mod
Override list), you must select the same MIDI controller number in the “Destination” eld
for the desired controller on the Multi Controls page. is must be done for each Zone that
you wish to apply the Mod override controller. e Multi Controls page allows you to set
entry/exit values as well as scaling and oset values for the Mod Override controller.
When the Mod Override parameter is selected, you can quickly select one of the K2700’s
physical controllers by holding the Enter button and moving the controller.
Output
is parameter species the physical audio output pair for the corresponding Aux Chain’s
output. e settings A and B refer respectively to the A and B physical audio outputs of
the K2700. Setting Output to Auto uses the output pair specied in the program on the
specied Aux Eects channel.