Kurzweil K2700 - Audio in FX (AUDIO IN) Page

Multi Edit Mode
Audio In FX (AUDIO IN) Page
7-44
Audio In FX (AUDIO IN) Page
Press the AUDIO IN soft button to access the Audio In FX page. e Audio In FX page
allows you to choose an FX chain to apply to the rear panel Audio Input jacks, and enable or
disable the use of any existing FX Mods in the selected Chain. Each Multi can be saved with
its own Audio Input settings, or be set to use the Audio Input settings set in Global Mode.
Mode
e Mode parameter determines whether the Multi will use its own Audio Input settings, or
whether it will use the Audio Input settings set in Global Mode.
By default, Mode is set to “Use Global Mode Eects”, which means the Multi will use the
Analog In FX settings on the Global Mode AUDIO I/O page (for details see AUDIO I/O on
page 9-27).
Set Mode to “Multi Specic Eects” to enable specic Analog In FX settings for the current
Multi. When “Multi Specic Eects” is selected, the FX Chain and Control Ch parameters
will appear.
FX Chain
When the Audio Input Mode parameter is set to “Multi Specic Eects”, you can use the
FX Chain parameter to select an FX chain to apply to the rear panel Audio Input jacks. To
edit a Chain, enter the Chain Editor by pressing the EDIT button (see Ch. 4 The Effects
Chain Editor for details).
When selecting an Audio Input Chain, the Chain may steal FX unit resources from other
channels in order to load. Because of this you may see some Channels on the FX page
become set to (Y) (higher numbered channels will be stolen rst).