Kurzweil K2700 - Page 268

Multi Edit Mode
Audio In FX (AUDIO IN) Page
7-45
Control Channel (Control Ch)
Use the Control Ch parameter to set the MIDI channel on which you wish to control Chain
Mods. See Channel on page 7-7 for details on Multi Zone MIDI Channels.
Eect Chain Mods are modulation controls which can be assigned to the K2700’s physical
controllers. Any Mods assigned within the selected Audio Input Chain can be controlled by
controllers assigned within the Multi.
To view the Mods of the selected Audio Input Chain, select the Chain eld and press the
EDIT button to enter the Chain Editor, then go to the Chain Info page (see Ch. 4 The
Effects Chain Editor for details).
To control these Mods, assign a Multi controller to send these CC numbers using the
Destination eld on the Multi Controls page (see CONTROLS Page on page 7-13 for
details). e Zone used to send these CC numbers must have a MIDI Channel which
matches the Audio Input Control Channel (see the Control Ch parameter, above). See
Channel on page 7-7 for details on setting the MIDI Channel of each Zone.