Kurzweil K2700 - Page 332

Global Mode
MIDI Page
9-21
Change Multis
e Change Multis parameter determines the exact timing of Multi changes when you
select a dierent Multi, either by a normal data entry method or via MIDI program change
commands.
Choose AllKeysUp to indicate that you want Multi changes to take place only when you’ve
released all currently held notes.
Choose Immediate to indicate that you want such changes to happen immediately when you
select the Multi.
Bank Select
e Bank Select parameter determines the controller number with which MIDI Bank change
messages are received.
For MIDI Bank change messages, various manufacturers have chosen dierent MIDI
controller numbers. Most have chosen Ctl 0, Ctl 32, or both. You can set this parameter to
any of the following three settings:
Ctl 0
MIDI Bank change messages are received with controller number 0.
Ctl 32
MIDI Bank change messages are received with controller number 32.
Ctl 0 / 32
MIDI Bank change messages are received with controller numbers 0 and 32.
PrgChangeMode
e Program Change Mode (PrgChangeMode) parameter determines the format of program
change messages received by the K2700.
Program Change Type For Use With
Extended
Bank changes and Program changes. A bank has 128
IDs. This is for controlling the K2700 from a generic
MIDI device or software.
K2600
Bank changes and Program changes. A bank has 100
IDs. The K2700 will recognize 21 banks, from 0 to 20.
This is for controlling the K2700 from a K2600. With
MIDI out from a K2600 into the MIDI in of the K2700, if
you select a Program number in the K2600, the same
Program number will be selected in the K2700.
Quick Access For use with other K2700’s.