Kurzweil K2700 - TEMPO

Global Mode
TEMPO
9-36
TEMPO
Press the TEMPO soft button to go to the TEMPO page. When the Clock Source parameter
is set to Internal (see Clock Source on page 9-22), the Tempo parameter sets the K2700’s
System Tempo. e Tempo parameter values are in units of BPM (beats per minute).
Set the Tempo parameter with the Previous/Next buttons, the Alpha Wheel, or alphanumeric
entry. You can also set the system tempo by using the TEMPO section of the front panel.
Press the TAP button a few times at the desired rate, or use the TEMPO knob.
In Program Mode, System Tempo can control the rate of each Program’s Arpeggiator and CC
Sequencer, as well as the rate of any tempo synced LFOs or Insert or Aux eects that each
program may use. Some programs may be programmed override the system tempo and use
their own tempo setting (for details see Tempo on page 3-27). All programs can be set to use
the System Tempo by setting the Global Mode Program Tempo parameter to “System”. For
details see Program Tempo on page 9-6.
In Multi Mode, System Tempo is ignored and the Multi Common Tempo of each Multi is
used for all programs in a Multi.