Program Mode
Controllers
2-7
SW1 (SUSTAIN) and SW2 Pedals
e SW1 (SUSTAIN) pedal defaults to controlling sustain, which will sustain any note that
is played while the pedal is pressed, for as long as the pedal is held.
For KB3 Organ Programs, the SW1 (SUSTAIN) pedal controls the Rotary Speaker speed,
changing between fast and slow. e Display shows “KB3” when a KB3 Program is selected.
e SW2 pedal defaults to controlling Sostenuto, which will sustain notes from any keys that
are being held when the pedal is pressed, for as long as the pedal is held.
e SW1 (SUSTAIN) and SW2 pedals can be enabled, disabled, or reassigned for each
Program in Program Edit Mode.
Global Mode can be used to set pedal overrides, which can change the pedal assignments for
all Programs.
Dual Switch Pedals
e SW1 (SUSTAIN) and SW2 jacks can be connected to dual switch pedals (2 pedals per
jack), allowing up to four switch pedals to be used. To emulate the 3 pedals of an acoustic
piano, plug a single switch pedal into the SW1 (SUSTAIN) jack, and a dual switch pedal
into the SW2 jack. For details see “Dual Switch Pedals” on page 1-12.
Continuous Switch Pedals (Half-Damper)
e SW1 (SUSTAIN) jack is also compatible with continuous switch pedals (Half-Damper)
that use a 1/4 inch tip-ring-sleeve plug (such as the Kurzweil KP-1H). When connected
to the SW1 (SUSTAIN) jack, a Half Damper pedal enables ner control of Sustain than a
standard switch pedal. Half Damper control is enabled for Programs in the Piano category.
Programs outside of the Piano category will respond to a Half Damper pedal as if it is a
standard switch pedal.
CC1 (VOLUME) and CC2 Pedals
e CC1 (VOLUME) pedal defaults to control Program volume (pre-FX).
For KB3 Organ Programs, the CC 1 (VOLUME) pedal controls organ swell. Organ swell
is similar to Program volume, except volume can not be turned all the way down to silence.
e Display shows “KB3” when a KB3 Program is selected.
e CC2 pedal typically controls FX such as wah.
e CC1 (VOLUME) and CC2 pedals can be enabled, disabled, or reassigned for each
Program in Program Edit Mode.
Global Mode can be used to set pedal overrides, which can change the pedal assignments for
all Programs.
To Next Page
Loading...
