Program Edit Mode
The PARAMS Page
3-11
KB3 Editor: The AMP Page on page 3-119
• Source 1, Source 2
KB3 Editor: The LFO+ Page on page 3-124
• RateCt, Trigger, Input a, Input b
Chain Edit Source Fields
The MOD Pages on page 4-3
• Source
FX LFO+ page on page 4-6
• RateCt, Trigger, Input a, Input b
Adding Physical Controllers
To assign a K2700 physical controller, select the source eld for the parameter, hold the
ENTER button and move the controller.
Adding MIDI CC Numbers
To assign a CC number to a source eld, enter a number from 1-31 or 64-95 with the
alphanumeric pad, then press Enter. A CC number for an external controller can also be set
by selecting the source eld for the parameter, holding the ENTER button, and sending a
CC value from the external MIDI controller.
Note: e K2700’s physical controllers each use one of the available MIDI CC numbers, so
you must choose one of the other available CC numbers when using an external MIDI
control source or else the parameter will also be controlled by a K2700 physical controller.
See the K2700 Physical Controller MIDI CC Numbers on page 3-7 for a list of CC
numbers used by the K2700’s physical controllers. Some MIDI CCs are also hard wired to
control certain program parameters or functions such as MIDI 5 (Portamento Time), MIDI
7 (Program Volume), MIDI 10 (Pan), MIDI 11 (Expression/Program Volume), MIDI 64
(Sustain), MIDI 66 (Sostenuto), so if you use one of these numbers the CC will always
perform the hard wired function, in addition to any other assignment you make.
To Next Page
Loading...
