Performance Features
Front Panel
3-6
The following table is the summary of controller assignment in Program mode (Internal Setup)
Controller Assignment MIDI Control Num
Knob A FX-A Depth MIDI 91
Knob B FX-B Depth MIDI 93
Knob C Assignable (Timbre) MIDI 06
Knob D Assignable (Timbre) MIDI 13
SW1 Octave Shift No MIDI Message
SW2 Assignable (Timbre) MIDI 09
SW3 Arp On/Off No MIDI Message
SW4 Assignable (Timbre) MIDI 29
MW Assignable (Vibrato) MIDI 01
Mpress Aftertouch MIDI 33
Ribbon Pitchbend MIDI 21/53
CCPed Expression MIDI 11
Setup mode
Buttons SW1-SW4 are programmable in Setup mode. They can have different functions for each
zone in every setup. In other words, you can change what one of these buttons does in Zone 1 of
a setup, for example, and it won’t change what that button does in the other zones of that setup
(or in any other setup).
EQ
The PC1 has its own three-band global equalization (EQ). See EQ on page 3-12 for details.
Solo
In either Program mode or Setup mode, pressing this button turns on the solo feature (if you’re
in Program mode, the PC1 switches to AutoSplit mode—a special performance configuration of
Setup mode.). When the Solo feature is on, (that is, when its LED is lit), pressing one of the Zone
buttons solos that zone, so you hear that zone only. See page 3-18 for more about muting and
soloing program.
The Zone Region
Main
In Program mode, this button takes you to AutoSplit mode—a special performance and editing
configuration of Setup mode. In this case, the Zone 2–Zone 4 buttons add splits or layers, as
indicated (See page 3-15 for more information about layering and splitting). In Setup mode, this
button selects Zone 1 for viewing or editing. Press it again to mute/unmute the zone.
Layer
In Program mode, this button switches the PC1 into AutoSplit mode, and adds a layer.
In Setup mode, this button selects Zone 2 for viewing or editing.
To Next Page
Loading...
