Kurzweil PC4 SE - Page 116

Multi Edit Mode
Controls Page
5-28
Scale
Use the Scale parameter to change the range of CC values sent by the controller (in
combination with the Add and Curve parameters). e Scale parameter multiplies the CC
values sent, changing the lowest and highest values sent by the controller. MIDI controllers
are limited to sending values from 0-127, even if the Scale and Add parameters are set to
produce values outside of this range.
By default, each continuous controller sends CC values 0-127, 0 at its lowest position, and
127 at its highest position. ese values can be multiplied by the percent value of the Scale
parameter in order to change the range of CC values. For example:
When when Scale is set to 100% (with Add set to 0 and Curve set to Linear), the controller
sends CC values 0-127, 0 at its lowest position, and 127 at its highest position.
Scale values 1-99% make the controller send a smaller range of CC values, allowing for ner
control of CC values. When Scale is set to 50% (with Add set to 0 and Curve set to Linear),
the controller sends CC values 0-63, 0 at its lowest position, and 63 at its highest position.
Scale values 101-300% make the controller send a values 0-127 over a smaller range of
controller positions, allowing for coarser control of CC values. When Scale is set to 200%
(with Add set to 0 and Curve set to Linear), the controller sends CC values 0-127, 0 at its
lowest position, and 127 at its middle position through its highest position.
When Scale is set to a negative number, the controller range is reversed. For example, when
Scale is set to -100% (with Add set to 0 and Curve set to Linear), the controller sends CC
values 127-0, 127 at its lowest position, and 0 at its highest position.
Add
Use the Add parameter to change the range of CC values sent by the controller (in
combination with the Scale and Curve parameters). e Add parameter adds or subtracts
from the CC values sent, changing the lowest and highest values sent by the controller. MIDI
controllers are limited to sending values from 0-127, even if the Scale and Add parameters
are set to produce values outside of this range.
By default, each continuous controller sends CC values 0-127, 0 at its lowest position, and
127 at its highest position. ese values can be added to the value of the Add parameter in
order to change the range of CC values. For example:
When when Add is set to 0 (with Scale set to 100% and Curve set to Linear), the controller
sends CC values 0-127, 0 at its lowest position, and 127 at its highest position.
When when Add is set to 64 (with Scale set to 100% and Curve set to Linear), the controller
sends CC values 64-127, 64 at its lowest position, and 127 at its middle position through its
highest position.