Kurzweil PC88 - Common Terms Glossary

Chapter 2 Diagnostics
The Sound/Setup Select buttons numbered 1 through
15 act as the indicators for the tests. The diagnostic test
and associated Sound/Setup Select buttons are listed as
follows:
CPU Test Sound/Setup Select |
Program ROM Test Sound/Setup Select 2
RAM Test Sound/Setup Select 3
NURAM Test Sound/Setup Select 4
MIDI UART Test Sound/Setup Select 5
Scanner Test Sound/Setup Select 6
Pi/O Test Sound/Setup Select 7
Timer Test Sound/Setup Select 8
Homer Test Sound/Setup Select 9
Sound ROM Test Sound/Setup Select 18
Marge Test Sound/Setup Select 11
Delay RAM Test Sound/Setup Select 12
LCD Test Sound/Setup Select 13
UGM Port Test Sound/Setup Select 14
Sound Test Sound/Setup Select 15
Debug Mode
Selecting Debug Mode executes all tests in sequence.
To enter Debug Mode,
Press the Zone 3 button.
At the completion of each test, the results will be
displayed in the LCD. To continue onto the next test,
press any button on the Control Panel or Keyboard key.
PC88 Service Manual
2-5